Water pumps are often the main device used to provide an entire home with water pressure. There are times of the year where homeowners turn them off, sometimes for extended periods of time.

Some switch to their rainwater collection system (best rain diverter options here) for a while, while some have to be away for longer periods of time.

Although this doesn’t cause any damage to the devices, water pumps tend to lose water pressure when they spend many months turned off.

When this happens, pipes receive very low water pressure. This mainly affects the water outlets located further away from the water pump, as they tend to receive almost no pressure. If some showers or sinks in your home are not discharging enough water, there’s probably an issue with your pump.

Thankfully, such an issue can be easily fixed. All you need to do is to prime the water pump, which can be accomplished with access to a simple garden hose and source of water which isn’t connected to the pump itself.

Easy Way To Prime A Water Pump

Step 1

Turn off the water pump before you begin. Then, make sure you have located a part of the water pump which gives access to the pumping system itself. You’ll be using this access to direct water into the tank with a hose. You can usually find something like this very near the water pump. If your tank has a trainer basket, you can start by looking there.

Step 2

Evaluate the state of the system before moving forward. A lack of usage in the water pump could mean that some parts of the system have gotten loose. You might need to tighten some corks and valves, and if you find any holes somewhere in the system, you’ll need to either replace the broken parts or fix them.

READ  How Long After Sealing Grout Can You Shower?

Step 3

Get a hold of a hose which has been used recently. Make sure everything’s okay with the hose – flush it if necessary. You’ll need to connect the hose to a source of water which isn’t dependent on the pump. Remember that the pump must be turned off for this process to work.

Step 4

Make sure the relief valves of the system are open and then place the hose in the location we discussed in Step 1, where there’s access to the water pumping system. You’ll be adding water into the tank using the hose. Turn on the hose and allow the air to flow through the system. This will produce some weird noises, but don’t worry: it’s completely normal.

Step 5

Keep checking your water pressure gauge. This will indicate when the water reaches the water pump’s tank. The gauge should start filling up once the air gets flushed away with the water. It shouldn’t take too long. You’ll hear the tank starting to fill up as the water from the hose reaches it.

Step 6

There should be a point in which water from the hose comes out of the other end. When this happens, the system has been fully pressurized, and you can remove the hose from the tank. Turn the hose off and move it away from the system.

Step 7

Turn on the water pump. Give the system some time to finish its natural cycle. If the process was successful, your water pump should turn off by itself once it’s done. If it doesn’t turn off, you’ll have to repeat the priming process once again. It could take a couple of tries – be patient.

READ  Is It OK To Leave A Gas Fireplace On Overnight?

Conclusion

Priming a water pump is a tedious process which could take you a couple of tries to get right. Be sure everything’s alright with your pump before starting, so you’re sure that no external factors are affecting the quality of your system.

We know this process could be tiresome. If you have any doubts or inquiries, be sure to share them in the comment section below.